How to Troubleshoot a Pur Water Filter
Introduction
We all need to drink water to live. Many people have filters on their taps but Pur has developed pitchers that can filter the water for you. These filters disinfect our water from microorganisms and other water impurities. Even though Pur has made these products relatively well, occasionally the filters on these pitchers do malfunction. If it is not time to change the filter entirely, follow the troubleshooting steps below to diagnose and repair the problem.
Difficulty: Easy
Things You'll Need:
- Water
- Mild soap
Instructions
Unfiltered Water Mixes Into The Filtered Water
Step 1
Remove the filter. Unscrew it from its position in the Pur water pitcher by twisting it to the left. When it is completely apart from the pitcher, pull it out of the pitcher.
Step 2
Clean the filter and the pitcher thoroughly. Use cold water and mild soap. Dry each piece very well.
Step 3
Screw the filter back into place. Make sure to twist it in to the right very tightly so that it is firmly set.
Unfiltered and Filtered Water Pours Out When I Tip The Pitcher
Step 1
Fill the pour tray with water. Fill the pitcher mostly to the top.
Step 2
Wait for the water to drain through the filter. You must wait for the entire pour tray to be filtered before you use the pitcher.
Step 3
Pour fresh, filtered water out of the pitcher. There will be no unfiltered water mixed in.
Tip
Change the filter every two months for optimum results.
Warning
Only use the filter for cold water. Hot water can damage the filter.
No comments:
Post a Comment